How to Measure your Square Spa with 2 Cut-off Corners
The information below details all the requirements for ordering a cover to suit a square spa with 1 cut corner. If you find the details too involved, you may prefer to contact us via one of the contact forms in the right hand column.
MEASUREMENTS & INFORMATION REQUIRED
- Length of the cut off corner
- Radius of the other 3 corners
- Height of Lip ( skirt length )
See Diagram 1 at left for required measurements
LENGTH & WIDTH MEASUREMENTS
Always measure from the outside of the spa shell ( not including any wooden frame or surrounds ) - see Diagram 2 above.
If the lip flares out slightly, measure adjacent to the bottom of the lip, see Diagram 3 above or video below
CUT OFF MEASUREMENT
The length of the 1 cut off is an important measurement to know for a correct fitting cover. See Diagram 4 above. If the corners of the cut off are curved, then see Diagram 5 or watch video below for information on how to measure correctly.
RADIUS OF 3 CORNERS
The corner radius measurement is very important for a correct fitting cover. The distance from the 90 deg. angle point back to where the spa begins to curve, is the radius measurement. See Diagram 6 above.
SKIRT HEIGHT MEASUREMENT
The distance from the top of the spa lip ( including any controls sitting less than 25 mm proud ) down to the bottom of the vertical spa lip, is the measurement required for ascertaining the length of the spa cover skirt. See Diagram 7 above & video below.
FURTHER INFORMATION REQUIRED
Click here View the Marine Vinyl Colours
Click here to view the Spa Cover strength options
Click here to view the Cover lock location options